|
SERVICES
Tip 5
SIBU alu-line ceiling sheets
SIBU Design products are generally simple to use and the new aluminium SIBU alu-line ceiling sheets are no exception, provided one uses the right tools and listens to some professional advice.
Cutting
A guillotine with 0.003-0.004” clearance is required for mechanical cutting. Only one sheet may be cut at the time, as otherwise burring can lead to the danger of injury. Electrical or mechanical sheet cutters are ideal for manual cutting and a circular saw with a special blade for non-ferrous metals can also be employed.
Designation HW 250x3,2x30 Z 80, FZ/TZ (HW = hard metal, 250 = external diameter, 3,2 = blade thickness, 30 = bore diameter, Z 80 = number of teeth, FZ/TZ = alternating flat and trapezoidal teeth)
Parameter: speed (n) = 3800 l/min
Advance = 5 m / min
Supplier: e.g.. Leitz, Art. No. WK 462 2 37
Handling SIBU alu-line DUO
During the handling of SIBU alu-line DUO ceiling sheets, special care must be taken that the composite aluminium film backing is not mechanical deformed due to finger pressure. Therefore, the ceiling sheet may not be held by the perforations. However, should the composite aluminium film be dented, this can be corrected by careful finger pressure on the back side of the sheet.
Protective film backing
This film should first be removed after sheet processing. Care is required to prevent any possible bending during the removal process.
Cleaning
Under no circumstances may abrasive cleaning agents be used.
Transport
In order to avoid damage, SIBU alu-line sheets may only be transported on suitable pallets.
<< back
|
|
