How to cut SIBU Design moldings

Cutting SIBU M50 edge moldings

SIBU M 50 moldings available in a range of colors, considering that all of them possess similar qualities the same cutting technique should be applied to all of them.

Machine cutting

Miter saw cutting is highly recommended for all M 50 moldings, use a 60-tooth saw blade (or grater), speed of 4,300 rpm.

Manual cutting

The profile must be laid on a solid ground with the back side up, which is cut (this is opposite side to the decorative surface). The profile is then bent off. Consequently, the profile must again be laid on the ground and the cutting edge should be carefully trimmed on the decorative side.

GET IN TOUCH

IDS Group is a Colorado based distributor of SIBU Design products. Our hours are Monday-Friday 8:00 AM-5:00 PM Mountain Time.

Visit us: 7200 E. Hampden Ave Denver, CO 80224
Give Us a Call: 303-745-2402
Copyright © 2024. SCS-CO, All Rights Reserved.